Forum: DIY (Do It Yourself)

Has anybody found jack stand pads that they think work well on the G35 coupe? I've seen some posts about the Kent Moore ones in the service manual not being available and some ideas about making my own, but just wondered if anyone had found a good quality one somewhere. Thanks

hey guys do you know anywhere around atlanta/gwinnett/dekalb/ doraville area to do cars that are lowered and bodykit Alignment?? doesn't matter about prices thanks guys!!

hey i just lucked out and ended up getting some used 06 projectors from a buddy that works at the local infiniti dealership here. I have recently opened up my 05 non projectors to do some halos and painting so i'm used to the wiring harness that it used.. However im not sure which plugs are...

I am still in the process just taking a break, it feels like 105 degree's outside.... anyhow here are some of the pics of the process... I used .50 Corragated Sheet of Aluminum, bought it for 23.99 (from Local Metal Dealer) 34x48 (Width x Length) Tools you will need:

My G35 is getting a little weak when starting up, in fact the other day it was dead and i had to jump start it. I went and got a battery check from autozone and he said that i needed a new one. Any recommendations? My other car has Optima red top in it, i was thinking about going with that again...

Found all this at http://www.technosquareinc.com/350reset.htm kind of hard at first, you just have to learn how to count with the second hand so you don't have to look at it. Please read all instructions and be familiar with them before any attempts. A stop watch or an analog clock with a...

Car was throwing a p1283 replaced the bank 2 sensor 1 still throwing codes. Don't know when daughter had plugs changed, g35 coupe 2004 70K, bought used, but I say probably never. Plugs are my next step. Anyone know what is the plug OEM for the car. Thanks Madness

I use K&N air filters, and like them, but have always worried that they will get oil on the electronic components of the MAF (Mass Air Flow) Sensor and alter its readings. I am not an engine management expert, but, in general, the MAF sensor measures the amount of incoming air to the engine and...

Could someone clarify for me the subject item. Reading through different forums clearing the codes with either the manual or computer method might not clear the self-learning. I have a p1283 change the o2 sensor and changed plugs. 70k on 2004 coupe. Cleared code manually. TSB on site says...

For 3 months I have been gathering information on doing this. No one has put together a full Do It Yourself on this, So here you go and enjoy! Ps. Try at your own RISK! First off I ordered a Autosport Wiring Harness so i didn't have to be upside down in the car to splice everything and...

2004 cpe-std. 18 in wheels: rubber bumpers in multi-level parking garages have rubbed against my wheels-leaving horrible black marks on the wheels(I was not driving). Have tried everything I know to remove them--anybody got any ideas?

i am in the marietta/kennesaw area and i am looking for someone to help me do install on the following parts on a 04 G35 coupe: headers test pipes y-pipe y-pipe back exhaust i am not very experienced on install but i know a little something, i just need someone with greater knowledge than...

Anyone know where I can pick some up locally? I'd like 2500 and 3000 grit. Reps for help.

Greetings to all! I recently purchased an 03 G35 and I need some much needed help. Today used my car all day and after I took it to wash and turned it back on my AC was on blast, temp at 60, and the Radio and AC consoles won't turn on for nothing! Funny thing is that the Nav right above the AC...

I just changed my spark plugs today, and once finished, i cranked up the car and the check engine light comes on. while driving i noticed the car lags tremendously and doesnt pick up for a good 2 seconds after pushing the accelerator. the check engine codes are P0113, P0123, P0223, P1122. I used...

How do you take the center console or should i say the stock 04 coupe's stereo out? I dont have a nav setup, just base model. Im in the middle of doing this right now with the bf and needa little advice before things start to break LOL jk ... If someone could post a diagram, that would help... ...

I have a 2003 G35 coupe with about 77K miles on it... Yes, I love to drive it! Just recently, with no warning signs... when I start up my car, the SERVICE ENGINE SOON light appears, as well as the VDC OFF light, and the SLIP light. All three of these lights are illuminated. My engine seems...

headlights are going greenish? O_o its not clear and transparent... but its like cloudy and greenish... how to get rid of it? could be on the inside too... not sure... but my friend buffed it and it went clean but remained cloudy still... and he said its on the inside..

Alright, royally fawked up first time, so here it goes again! The tools - got more than im guna use but basically - Valspar Satin Black paint - Rustoleum primer - Valspar Yellow paint - Polycrylic Gloss Clear coat. - shud give me a shine between gloss and satin. - Various painters tapes,...

anybody got the diy for replacing the in cabin microfilter? i haven't replaced mine and its been a year so I figure its time. also best place to pick them up, would advance have them or is it a special type filter?

Ok Here we go... Firstly Special thanks to KemicalMoz from E-bay. He had everything sorted out and communicated every step of the way when i purchased them from him. His AOL S/n is FourGPowerSales... So if you guys are ever interested in G or Z parts consider him an alternative, he's a good...

Hey guys, I wanna pull out my bose amp and sub bc now they are unused and dead weight... anyone know how or have a diy i can look at? its out of an 05 sedan... thanks, Theo.