View Full Version : Aftermarket HU peoples come in there...where to RUN RCA's
01-05-2007, 09:55 PM
For those that have aftermarket HU's with amps. What direction did you guys run your RCA's? Did you go down the center or down the drivers side edge?
01-05-2007, 09:57 PM
rca down the driver side
power down the passenger side
01-05-2007, 09:58 PM
i just put them along the edge pull the panel off on clip the carpet then just push them down there. there is plenty of room and you will see a wire loom already in there so it doesnt make the carpet bludge out.
01-05-2007, 10:53 PM
Do all double din units need a small plastic filler piece to close all gaps between the HU and the finisher. If so what should I use? A sheet of abs plastic trimmed to fit?
01-05-2007, 11:15 PM
my head unit came with one as did jb's i think
so i dont know what you would need to use
01-05-2007, 11:33 PM
which HU's do you guys have?
01-06-2007, 03:13 AM
i have teh kenwodd ddx 7015. there is apost on here of my install.
jb has an elipse unit not sure of the model number
01-06-2007, 09:00 AM
I ran my wires like Daniel - RCA on the left and power/gps/sirius on the right.
My Kenwood came with a trim piece that does not fit, so I have a gap that I haven't fixed yet.
jb's Eclipse didn't come with one either. He has his install shop make one.
01-06-2007, 02:52 PM
Powered by vBulletin™ Version 4.1.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.