View Full Version : Borla vibration
01-24-2004, 08:53 PM
I need someones advice. I am having a vibration from my Borla exhaust at the rear sway bar, it is touching. Any suggestions? Thanks Karl
01-25-2004, 08:31 PM
01-26-2004, 03:10 AM
You might have to loosen up the two last sections and rotate the pipe away. I believe that section has a curve in it.
Yup, just move the pipe to go around the sways better and it should do it. Borla is lots of pieces so there is tons of room for error, just check everything again.
01-26-2004, 07:50 PM
02-01-2004, 02:17 AM
Did you get your exhaust spot welded? If not, you may want to have this done.
Powered by vBulletin™ Version 4.1.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.